Gallery

Visual evidence of my technical talents exhibited over the past 20+ years.

ALL
CoorsTek
Custom Enterprises
Custom Enterprises 2

Old Blue grinder

I worked on this machine in the finished product

This is a (Body) high pressure press I worked on the hydraulics constantly leaked from fittings and a solid steel pipe.

I worked on totally destroyed way covers for lathes. The coolant constantly coronated the metal to the point where it had to be replaced.

A centerless grinder that only I could keep running with and old PLC and hydraulics that controlled the feeds

This is the control that the speedfam runs on

The SpeeddFam at work , the DRO scale came up through the center. I re-worked the scale mount and increased the ability to accommodate taller pieces that needed ground down to specifications.

This is one of the SpeedFam machine I worked on the DRO measurement system and built a new safety guard

The grinder PLC that controlled the speeds and feeds

This is a a bowl making machine that uses the body of ceramics. I was able to keep the machine running with custom made parts.

Connected high pressure pipe

This was the safety shield I made for the SpeedFam. the door raised up with buttons and pneumatic cylinder.

This was a project that Gates Rubber company contracted us to build for them

This is the finished product for Gates belt testing machine. The test was to put a belt in a heated enclosure for a certain time and temperature at a certain speed for endurance testing.

Pneumatic drill fixture we made for Bestop roof supports

this machine drilled two different sizes of supports for Bestop

This was a Pinner machine we made for Texas Interments, The tubes that held integrated chips needed a pin in the end to hold the chips in

This was a machine me and my father designed from the ground up that drilled holes in the support for Bestop manufacture.

The machine had pneumatic drills that drilled holes in two sizes of top supports, the machine is still in use today 2025

we made this foam tape applicator for Bestop

This is a wire forming machine we made to make the handles for the 1st tool at CablePro tools

This was a test fixture we made for United Cable in 1988 when tv top boxes were used to bring channels to homes and we made a lock out filter that locked out pay per view tv chanels

Me and my father made this coin cou ter for counting 40 quarters and putting them into wrappers of $5

These were display read outs we made for a customer that put their electronics inside the display enclosure

In addition to brochures and pictures I made this tool display to put into the customers location so installers could pick out the tools they needed. Kelly cable

We made this tube bender and press for bending conduit into cable caddies

This was one of the 1st cable caddies we made for caring a cable roll

Eric Kesinger

Gallery

Old Blue grinder

Eric Kesinger

Pages

Quick Links

Follow My Socials